Tosch Laboratory, Inc.
Easy steps to design and email you restoration to Tosch Laboratory
The following diagrams show the step by step procedure for emailing your design to Tosch Laboratory. 

1.  For e.max crowns click on the the "Biogeneric" Design Technique, as usual.  For Luna Translucent Zirconia Crowns or Bridges, select "Reduced"       (indicated in red, below) then select the tooth as usual.  Luna Zirconia can be used to create bridges.
First, Select Crown or Bridge
2nd For Luna Crowns or Bridges, select "Reduced"
2.  Select the appropriate material for the Restoration.  For Luna Crowns, Choose Vita InCeram YZ  (Do not select flip blocks unless you are       designing a bridge 30 mm or more in length.)
For Luna Crowns Select  Vita YZ
Check to be sure the scan is properly oriented in the "Determine Insertion Axis" window.  If the restoration is reversed, as below, rotate before clicking "Next"
Scan after rotation and adjusting insertion axis.
3.  Complete the design as normal and click next.  For Luna Zirc Crowns the window below will appear and say "Reducing Restoration" at the       bottom left corner.  Simply click next and continue to the milling preview.
For Luna Zirconia Crowns this "Reducing" window will appear.  Click next again and continue to Milling Preview Window.
For Luna Full Zirconia Restorations the sprue must be on the Lingual or Buccal.
You are now ready to Save the restoration to your desktop and email it to Tosch Laboratory.